Boiler Accessories
Improve energy efficiency and reduce cost with the proper boiler accessories to keep your boiler operating at peak efficiency.
Condensate Recovery
Cleaver-Brooks Condensate Return System
Returns condensate back to the system to improve energy efficiency and reduce chemical, make-up water and sewer disposal costs, while helping meet environmental regulations.
- Design
- Simplex or Duplex; single or 3-phase
- Size range
- 10, 15, 25, 35 gallon capacity
- Use
- Steam and hot water applications
Fabtek Condensate Return System
All Duplex and Simplex units include a 304SS tank, SS vertical flange-mounted centrifugal pumps, NEMA 1 float switch (Simplex) or mechanical alternator (Duplex), and an SS sight-gauge assembly. Pumps and tanks are interchangeable, and the 304SS tank carries a 20-year warranty against corrosion failure.
- Design
- Simplex or Duplex
- Size range
- 6–150 gpm (2,500–37,500 PPH)
Energy Recovery
Cleaver-Brooks Heat Recovery Solutions
Reduce costs and environmental impact by recovering waste heat or steam and reusing it elsewhere in the system.
- Stack economizer — recover heat from flue gases that would otherwise be wasted and save up to 5% on your fuel bill. For high make-up systems, a two-stage economizer adds a second stage to preheat deaerator make-up water, raising boiler efficiency up to 95%.
- Condensing economizer — save on fuel and increase fuel-to-steam efficiency up to 90%.
Cannon Boiler Works Economizers
Three parameters determine the best heat-recovery product for you: fuel type, acceptable exhaust backpressure, and inlet water temperature.
- Feedwater Heater — small boilers, natural gas, non-condensing flue gas. Inlet 150–250°F.
- Gas Condensing Water Heater — small and large systems, natural gas, condensing flue gas. Inlet 40–150°F.
- Heavy Duty Economizer — large systems burning dirty fuels, non-condensing flue gas. Inlet 200°F minimum.
- On-Demand Economizer — fits where others won’t; natural gas, condensing flue gas. Inlet 40–150°F.
- Dual Stage Economizer — heats two streams with one economizer; small and large systems, condensing or non-condensing. Inlet 40–250°F.
Exhaust Solutions
Exhaust and venting products — including AMPCO stacks, Jeremias venting, and U.S. Draft dampers — are covered on our dedicated Exhaust Solutions page.